CodingIsBest

How To Make Raspberry-pi ip-Address Static and show an virtual window of raspberry-pi on Windows desktop through VNC-Viewer STEP  1: Disconnect your Desktop from Windows operating system. STEP  2: Connect your Raspberry-pi to your pc install the Raspbian from the below link STEP  3: Download BalenaEtcher which is basically an image flasher which is going to flash the image of the OS that is Raspbian on the SD card on any USB  for further details go to the link below and download it. Also you can download Win32diskmanger to flash the OS STEP  4: Now as we download the Raspbian and also we flash it now Download the VNC viewer through the below link  STEP  5: Now open the Terminal on Rasberry-pi and write the following commands 1. ifconfig : Check out the  ip-address , sub-net mask 2. netstat -nr : This command will tell you about the  gateway address 3. sudo nano /etc/network/interfaces : This command will give the network file name 4. ctrl-x : To close the file u

Arduino UNO R3 Arduino Uno is a microcontroller board based on ATmega328P . It has 14 digital input/output pins 6 Analog pins a 16 MHz quartz crystal oscillator with USB connection ,a power jack , an ICSP(In-Circuit Serial programming) header and a reset button actually it has two reset buttons . Also Arduino uno has RX-0,TX-1 that is receiving and transmitting pins on board. Arduino uno contains  AREF pin which means Analogue-Reference IOREF pin this pin is provides a voltage  reference at which the microcontrller works 3-ground pins 3-Vcc pins Basically the purpose of creating an Arduino Uno is to Control the sensors and the actuators so that it can work accordingly the data which we provide with the help of software . Nowadays people using Arduino Uno in many fields it has very huge scope in  the field of  IOT(Internet Of Things). Also in my current project which is 2D-printer we have used Arduino Uno which sense the Data and accordingly move the X-Y pla